「鹤岗道闸」广告道闸安装流程和步骤
1.机箱固定后，把广告道闸主杆插进杆把，用六角螺丝和垫片，弹垫，螺母固定好，然后，把闸杆LED灯线，通过主轴孔，引进道闸。
After fixing the chassis, the main rod of the advertising gate into the lever handle, fix it with hexagonal screw and gasket, bullet pad and nut, and then introduce the gate through the main shaft hole through the LED lamp line of the gate.
2.把连杆固定在广告道闸的机箱背面相应的位置，用螺丝固定。
Fix the connecting rod at the corresponding position on the back of the box of the advertisement gate and screw it.
3.将广告道闸的副杆与连杆连接在一起，用螺丝固定。
Connect the auxiliary rod and connecting rod of the advertisement gate and fix it with a screw.
4.翻板安装完成后，将另外的撑杆也插入广告道闸的主杆与副杆的插槽中。
After the turning board is installed, the other supporting rods into the slots of the main and auxiliary rods of the advertisement gate.
5.将组装好的广告道闸的翻板分别插入主杆与副杆的插槽中。
Insert the flip board of the assembled advertisement gate into the slots of the main and auxiliary rods respectively.
6.翻板安装完成后，将另外的广告道闸的撑杆也插入主杆与副杆的插槽中。
After the turning board is installed, the brace of the other advertisement gate into the slot of the main and auxiliary poles.
7.撑杆安装到位后，然后将主杆前封板固定在主杆与副杆上，用螺丝锁紧，确保广告道闸发翻板和撑杆之间不能随意松动。
After the support rod is installed in place, the front cover plate of the main rod is fixed on the main rod and the auxiliary rod, and the screw is used to lock it, so as to ensure that the flip plate and the support rod of the advertisement channel can not be loosened at will.
8.广告道闸的闸杆主体部分，安装调试完成后，可以安装落地撑杆部分，用螺丝锁紧。
After installation and commissioning, the main part of the brake rod of the advertisement gate can be installed with the floor brace and locked with a screw.
www.1688ddm.cn
艾经理
13940183063
|
